Jensen JCR-298 User Manual page 7

POWER CONNECTION
1. Plug the cord of the power adaptor into the DC IN JACK (#15) located on the back
of the JCR-298.
2. Plug the power adaptor into a household wall socket. The unit is powered up and in
standby mode when you see the display turn on and begin flashing.
Battery Back-up system
• The radio is equipped with a battery back-up system. It requires 2 x AAA batteries
(Not included).
• Open the BATTERY DOOR (#12) on the back of the unit. Insert the batteries into
the battery compartment and make sure the positive and negative (+ or -) sides of
the batteries are in contact with the corresponding terminals in the battery
compartment. Replace the BATTERY DOOR (#12).
• If a power outage occurs, the unit automatically switches to the battery power
supply and keeps the clock settings.
• When replacing the battery, do not disconnect the power adaptor. Otherwise, all
clock and alarm settings will be lost.
Note:
The unit will still operate without the batteries installed, but the time and alarm settings
will be lost and have to be reset in the event of a power interruption or failure.
CAUTIONS:
1. Do not mix old and new batteries.
2. Only use good quality/name brand batteries.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
BACK VIEW
E-6
1.5V AAA
1.5V AAA
INSTALL BATTERIES