Jensen JCR-298 User Manual page 10

Wake to Radio (AM or FM) - Turning the "wake to" Radio ON:
The Radio will automatically turn on when the alarm time is reached. The
corresponding RADIO 1 or RADIO 2 indicator will flash.
The unit will start playing the last radio station you listened to when the wake time
is reached, so make sure the station is set to the one you
The volume level will start out low and gradually increase to maximum volume.
Press the SNOOZE BUTTON (#1) to temporarily turn off the radio, or
SOURCE/STANDBY BUTTON (#2) to turn the radio off.
If no buttons are pressed when the radio is playing, it will continue playing for 60
minutes and then turn off automatically.
Wake to Bluetooth
NOTE: In order to wake to a Bluetooth device, the device must be paired with the
JCR-298 prior to using the wake to Bluetooth.
The Bluetooth Device will automatically connect with the last connected Bluetooth
device and resume playback when the alarm time is reached.
BT 1 or BT 2 indicator will flash.
The unit will resume playing the last music or audio you listened to on the
Bluetooth device when the wake time is reached.
The volume level will start out low and gradually increase to maximum volume.
Press the SNOOZE BUTTON (#1) to temporarily turn off the Bluetooth device, or
press the SOURCE/STANDBY BUTTON (#2) to turn the Bluetooth device off.
If no buttons are pressed when the Bluetooth device is playing, it will continue
playing for 60 minutes and then turn off automatically.
NOTE: The JCR-298 will automatically switch to WAKE TO ALARM if it cannot
connect with the Bluetooth device or if the Bluetooth device was not paired properly.
Review the Alarm time setting:
In standby mode, tap the ALARM 1 / ALARM 2 BUTTONS (#3 / #4) once. The
corresponding alarm indicator and alarm time will be flashing on the display.
The unit will automatically return to standby mode if no buttons are pressed within 5
seconds.
Turning the daily alarms OFF:
In Standby mode, repeatedly tap the ALARM 1 BUTTON (#3) to step through the
"wake to" options shown on the left side of the display.
Alarm 1 -> Radio 1 -> BT1 - > OFF (all indicators off and returns to the current time)
The ALARM 1 time will flash on the display as you step through the options.
All ALARM 1 options are disabled when the indicators are off and the current time
is showing on the display.
Turning off ALARM 2 will follow the same steps as ALARM 1 above, but you will be
using the ALARM 2 BUTTON (#4) and the ALARM 2 indicators will be on the right
side of the display.
Notes:
• For setting a one-day alarm, set the desired alarm time the day before following the
"Setting the alarms" section above.
• The alarm will sound the next day at the set alarm time.
• After turning off the alarm, follow the "Turning the daily alarms OFF" section
above to prevent the alarm from sounding again the next day.
- Turning the "wake to" Bluetooth ON:
want to wake up
E-9
to.
press the
The corresponding