Renaming The Pump; Updating Firmware; Setting The Tube Service Life; Resetting The Program To Factory Settings - D-D The Aquarium Solution Kamoer FX-STP WIFI User Manual

In this you can:
 Rename the pump.
In settings tap on 'Name' and the settings page will open. Enter the new name and tap 'Save' in the
top right corner.
 Update firmware.
If the firmware on the device is up to date 'No Update' will be displayed. If updates are available tap
on the update and follow the instructions on screen. Do not close the app or power down the unit
during this process.
 Set tube service life
This option is used as a reminder of when the Pharmed tube in the pump head needs replacing. It is
advisable to do this to keep optimal performance of the pump and to prevent the chance of a worn
hose splitting.
Select tube life and enter the number of operating hours that the tube is to be used for before
replacing. This will vary depending on the flow rate that the pump is set at. At higher flow rates the
hose is compressed more frequently by the rollers and as a result will need replacing sooner.
Lubricating the rollers with a silicone grease on a frequent basis will help to ensure that the maximum
life can be achieved and that the head runs smoothly.
 Calibrate the pump
Used to calibrate the unit to ensure correct flow rate. Please see calibration in this instruction manual.
 Reset program to factory setting
Use this function to factory reset the pump. This will remove all programmed settings. To reset tap on
'Factory Settings Reset' and select reset. The unit will beep and temporally go offline. When the LCD
screen shows 'Work Mode NET 0' the unit is reset and ready to programme, this may take a couple of
minutes. The pump will not be removed from the app or cloud. Do not power off the unit during this
process.
 Remove device from the app
To remove the device from the app tap on 'Remove Device' and select remove. The unit will still be
connected to the associated router. The FX-STP can be added back to a mobile device connected to
the same network using the Kamoer Remote App. Tap on the '+' symbol in the devices page and
choosing the pump from 'Local Devices'.
The pump can also be removed in the app device page. Press and hold the icon of the device you
want to delete. A prompt will appear at the bottom of the screen. Tap on the trash can symbol in the
bottom left to confirm.
10
Version 1.0