Pump Specifications; Installation - D-D The Aquarium Solution H2Ocean COMPACT ATO Product User Manual

CONTROLLER & DUAL SENSORS
ATO Level Sensor

PUMP SPECIFICATIONS

1. Power Input: 100-240 VAC 50-60 Hz
2. DC Pump: Head - 250 cm. Flow Rate - Up to 280 lph

INSTALLATION

1. Mount the sensor head at the normal water level on the tank/sump
using the magnet*, with the water level reaching the lower of the two
sensors as shown.
2. Connect the PVC tube to the pump and cut one piece to a length
so that it is higher than the maximum water level in the top-up water
reservoir. Connect the siphon break into this tubing, and position the
remaining PVC tubing over the tank/sump using the universal holder.
Make sure the open end of the ATO tube does not immerse in the
sump/ tank water under normal operating conditions.
3. Connect both the DC pump and power adapter with the controller and
then switch on power.
*Please avoid setting up the sensor in an area with micro bubbles.
4
H 2 O c e a n C o m p a c t ATO
Failsafe sensor
Pump
w w w.t h e a q u a r i u m s o l u t i o n . c o m
Power