Installing The Driver In An Existing Netware 5.1 Or; Server - Adaptec RAID 2120S Installation Manual

4 Begin installing NetWare 5.1 on your server as instructed in
your NetWare documentation. Make sure that you have the
aacraid.ham and aacraid.ddi files available on the driver disk
created at the beginning of this chapter.
5 When the Device Types screen appears, check the Storage
adapters list and select Modify to add another driver.
6 Select the Storage adapters and press Enter. A list of recognized
controllers will be displayed. If AACRAID was detected, delete
it.
7 Press the Insert key to add another driver. The list of available
drivers will be displayed on this screen.
8 Press the Enter key to scan drive A for the driver. You have a
choice to press F3 and specify the path to the driver if it does not
reside on drive A.
9 Once the driver is selected, the installation process returns to
the parameter screen.
10 Verify the list of the loaded drivers and from the lower window
menu, select Continue and press Enter.
Note: If the driver installation process does not complete
successfully you will be taken back to the server console to
examine the cause of the failure.
Installing the Driver in an Existing NetWare 5.1 or 6 Server
In this scenario, you are integrating an Adaptec SCSI RAID
controller into an existing Novell NetWare 5.1 or 6 server as a
secondary controller.
To install the driver:
1 Upgrade your NetWare server to the minimum patch level
specified by Novell.
2 Make a backup copy of the driver.
3 Shutdown the server.
4 Install and configure the Adaptec SCSI RAID controller as a
secondary controller according to the instructions in
Installing the Driver
Chapter 2.
3-15