Adaptec RAID 2120S Installation Manual page 29

Adaptec SCSI RAID 2120S/2200S Installation Guide
4 Using the arrow keys again, highlight the three drives to be
used for the RAID 5, press Insert when a desired drive is
highlighted. Selected drives will be displayed in the box on the
right side of the display. When the desired three drives are on
the right side, press Enter to continue.
5 A red warning box appears. Press Y, then Enter to continue. The
system will initialize the selected drives, in a few seconds.
6 The Array Configuration Utility screen reappears. Using the
arrow keys, highlight Create Array, then Enter.
7 Using the arrow keys as in
the RAID 5, press Insert when a desired drive is highlighted.
When the desired three drives are on the right side, press Enter
to continue.
8 On the next screen, most of the default entries will be used by
pressing Enter when they are highlighted. Make the following
selections and entries:
Property Line Displayed
Array Type
Array Label
Array Size
Stripe Size
Read Caching
Write Caching
Create RAID via
[Done]
A Creating Array window appears briefly. Press Enter to
continue with the array configuration.
Note: The array will be usable immediately, but will
continue to build until finished, impacting performance
until it is done.
2-10
Step 4, highlight the three drives for
Entry or Selection
Select RAID 5, press Enter
Type a suitable name in the space
provided, press Enter.
Enter. Press Enter again to use
the default drive granularity of
GB.
Enter
Enter
Enter
Enter
Enter