Adding The Controller To An Existing System - Adaptec RAID 2120S Installation Manual

5 Insert the driver disk you created at the beginning of this
chapter. Press S to specify that the driver is located on the
floppy disk, and press Enter. The installation process will read
the disk looking for a suitable driver.
6 When the Adaptec SCSI RAID driver is found, press Enter.
Follow the on-screen instructions, responding as needed to
complete the installation.

Adding the Controller to an Existing System

In this scenario, you are adding an Adaptec SCSI RAID controller
to an existing Windows NT system.
To install the driver:
1 Before adding the controller or shutting down the system, open
the Control Panel. Click the SCSI Adapters icon. Then select the
Drivers tab and click Add.
2 Insert the driver disk you created at the beginning of this
chapter, then click Have Disk. Since the driver is also on the
installation CD, you may wish to insert the installation CD and
have Windows search it for the driver. It would be located in a
driver folder at <drive letter of the CD>/packages/
Windows_NT.
3 Select Adaptec SCSI RAID 2xx0S Controller.
4 After the driver is loaded, shut down the system.
5 Insert the Adaptec SCSI RAID controller. For installation
details, refer to
6 Start the system.
7 If you are removing an existing controller, you should also
remove the old driver. To do so, open the Control Panel, click
the SCSI Adapters icon, select the old driver, and click Remove.
Chapter 2.
Installing the Driver
3-9