Red Hat Linux - Adaptec SCSI RAID 2010S Installation Manual

Adaptec SCSI RAID 2010S/2015S Installation Guide
6 When prompted, click Have Disk.
7 Select Adaptec I
8 After the driver is loaded, shut down the system and remove
the disk.
9 Restart the system.

Red Hat Linux

The following sections describe procedures for installing the
Adaptec ZCR controller with Red Hat Linux.
Installing the Driver in a New Linux System on page 3-9
■
Installing the Controller in an Existing Linux System on page 3-10
■
Installing a Newer Driver on page 3-12
■
The Adaptec ZCR controllers supports Red Hat 7.3.
Note: For the most up-to-date information on Adaptec's
support of Linux, or to download driver sources, visit
linux.adaptec.com
!
Caution: When adding a ZCR controller to an existing system,
backup all data from system drives prior to the installation. If
the boot device is connected to one of the on-board SCSI
channels, or you plan to use a RAID array as a boot device,
the operating system will need to be reinstalled after
installing the ZCR controller.
3-8
O RAID Host Adapter Driver for NT 4.0.
2
.