Table of Contents
Advertisement
Section 2
General Description
pecification
S
Dimensions
H: 19.2"; 488 mm (including feet) W: 10.49"; 266 mm L: 26.9"; 683 mm (Including handles)
Weight
Not including guns and cables 172lbs (78kg)
North America Supply Voltage
Welding Capability
Model
Inch capacity
SW750
1/2"
Intended Usage
This power source supports welding QuikLinx clips with the autofeed Quicklinx tool.
This power source also supports welding standard arc studs using a standard draw arc weld tool in accordance with
AWS C5H; AWS D1.1; ISO14555 and CSA W59
This power source does NOT support both types of tools at the same time.
Duty Cycle
Power source is rated at a 5% duty cycle. The unit can deliver the full rated
current for 1 full second on; followed by 19 seconds off. While it is possible
to deviate from this specific duty cycle (i.e. short rapid bursts or welds
lasting longer that 1 second) the off time must be adjusted accordingly
or the unit will go into thermal shut down.
Storage and Operating Environment
• The Power Supply or Welding Unit should be located on
a flat, level floor: It should not be tilted more than 15°
in
any
direction
transportation. Unit may tip if tilted in excess
of the 15° maximum.
• Near the work area to limit welding cable
length (shorter lengths are preferred).
• In a dry area away from moisture.
• Placed to protect it from grinding dust and
other contaminates.
• To provide minimum of 12" clearance on all sides for cooling.
• The factory equipped feet are not removed (again for cooling).
230 V 3 phase
Metric Capacity
13mm
during
operation
and/or
12 inch (300 mm)
Installation & Set Up
460 V 3 phase
QuikLInx
All styles of QuikLinx Clips
9 9
575 V 3 Phase
12 inch (300 mm)
Feet must be in place
for proper cooling.
Advertisement
Table of Contents
