Table of Contents
Advertisement
Section 3
System Check
Contact with work
Trigger Indicator
Thermal Overload
Push Buttons
The push buttons have an acceleration feature built into them. As you press and hold the buttons, the values change by
greater amounts. For example, you would like to set the welder to 750 amps, but the display is showing 50 amps. By
pressing and holding the current up button the display will jump in large steps towards 750 amps.
Use the push buttons to adjust the current and the time to the desired values for the fastener to be welded.
Use gas if appropriate (light will not be lit if off). Gas is discussed later in this manual.
Normal
Gas Mode
Gas Mode Indicator
16
Operation
Current Increase (UP)
Current Decrease (Down)
Time Increase (UP)
Time Decrease (Down)
Advertisement
Table of Contents
