User Safety - Xylem Bell & Gossett Ecocirc+ 20-18 Installation, Operation And Maintenance Manual

1 Introduction and Safety
Hazard levels
Hazard level
NOTICE:
Special symbols
Some hazard categories have specific symbols, as shown in the following table.
Electrical hazard

1.3 User safety

All regulations, codes, and health and safety directives must be observed.
The site
• Observe lockout/tagout procedures before starting work on the product,
such as transportation, installation, maintenance, or service.
• Pay attention to the risks presented by gas and vapors in the work area.
• Always be aware of the area surrounding the equipment, and any hazards
posed by the site or nearby equipment.
Qualified personnel
This product must be installed, operated, and maintained by qualified
personnel only.
Protective equipment and safety devices
• Use personal protective equipment as needed. Examples of personal
protective equipment include, but are not limited to, hard hats, safety
goggles, protective gloves and shoes, and breathing equipment.
• Make sure that all safety features on the product are functioning and in use
at all times when the unit is being operated.
4
DANGER:
WARNING:
CAUTION:
Electrical
Hazard:
Ecocirc+ 20-18 Installation, Operation, and Maintenance Manual
Indication
A hazardous situation which, if not avoided, will
result in death or serious injury
A hazardous situation which, if not avoided, could
result in death or serious injury
A hazardous situation which, if not avoided, could
result in minor or moderate injury
Notices are used when there is a risk of equipment
damage or decreased performance, but not
personal injury.
Magnetic fields hazard
CAUTION: