Communications With Dcc; Communications With Type 1 Devices; Communications With Type 2 Devices; Supplier Message - Honeywell AS302P Operating Instructions Manual

36
AS302P Single Phase Smart Meter
____________________________________________________________________
•
On joining a ZigBee SEP v1.2 Smart Metering Home Area Network, the AS302P is capable of generating and
sending an Alert to that effect via its HAN Interface.
•
Restricting Personal Data Available for Type 1 and Type 2 Devices from a defined UTC Date and Time
•
A command to re-establish communications is supported. This will - seek the appropriate frequency; re-establish
communications links above; generate an event in the Event Log; generate an alert via the HAN.
Where the meter has Communications Links already established it shall be capable of not executing the
Command.

21.4. Communications with DCC

The meter communicates with the DCC WAN through the Comms Hub via the ZigBee HAN.
The meter is able to:
•
Receive Commands
•
Send Responses
•
Send Commands
•
Send Information
•
Send Alerts
The Commands that are support to DCC are given in Appendix C.

21.5. Communications with Type 1 Devices

The meter is capable of supporting seven communication links with Type 1 Devices (of which five are reserved for
HCALCS). For each Type 1 Device the meter can:
•
Receive Commands
•
Send Responses
•
Send Commands
•
Send Information
•
Send Alerts
The Data that is provided to a Type 1 Device is given in Appendix D.
The Alerts that are defined to be sent on the HAN are given in Appendix B.

21.6. Communications with Type 2 Devices

The meter is capable of supporting four communication links with Type 2 Devices. For each Type 2 Device the meter can:
•
Send Information
•
Send Alerts (these will be same Alerts as sent to the Type 1 Devices)
The Data that is provided to a Type 2 Device is given in Appendix D.
The alerts that are defined to be sent on the HAN are given in Appendix B.

21.7. Supplier Message

The meter stores Messages from the Supplier that need to be provided to the Customer on either a Type 1 or a Type 2
Device.
© Honeywell - M450 001 1D - 23.05.2019