Table of Contents
Advertisement
Section 1: Introduction
January 2017
Section 1: Introduction
This manual is valid only for ERNG-X . The instructions for individual components must also be
read and followed .
• ER5000 Getting Started (DOPSM2065XML2)
• ER5000 Series User Manual (DOPSM2064X012)
• Safety, Installation, Operations and Service Manual (DOPMS2080X012)
Section 2: Before You Begin
waRNING
Do not install, operate or maintain an ERNG-X or any associated equipment,
without reading and fully understanding the installation guidelines and
operating instructions for every component of your application. To avoid death,
serious injury and/or property damage, it is important to carefully read,
understand and follow all contents of this Product Manual, including all safety
cautions and warnings. If you have any questions about these instructions,
contact your TESCOM sales office before proceeding.
Make sure that the components and materials used in the fluid handling system
are compatible with the fluid and have the proper pressure rating. Failure to do so
can result in death, serious injury and/or property damage. Inspect the regulator,
valve and accessories for physical damage and contamination.
Do not connect the regulator, valve or accessory if you detect oil, grease or
damaged parts. If the regulator, valve or accessory is damaged, contact your local
TESCOM representative to have the regulator cleaned or repaired.
Do not modify equipment or add attachments not approved by the manufacturer.
Failure to do so can result in death, serious injury and/or property damage.
Before proceeding with any installation procedures:
• A lways wear protective clothing, gloves and eyewear to prevent personal
• D o not remove the ERNG-X or any other individual component of the product
• D isconnect any electric power or a control signal to the ERNG-X prior to
• D isconnect any operating lines providing pressure to the ERNG-X prior to
• U se bypass valves or completely shut off the process to isolate the ERNG-X
• U se lock-out procedures to be sure that the above measures stay in effect
• C heck with your process or safety engineer for any additional measures that
2
injury or property damage.
while the system is pressurized.
installation or maintenance.
installation or maintenance.
and associated equipment from process pressure prior to installation,
maintenance or removal.
while you work on the equipment.
must be taken to protect against process media dangers.
ERNG-X
dopsm2107x012
Section 1: Introduction
Advertisement
Table of Contents
