Table of Contents
Advertisement
Setting Termination
The SCSI bus must be terminated correctly to
ensure proper operation of the AHA-1510A host
adapter. Terminators must be installed in the first
and last physical devices on the SCSI cable and
removed from all other SCSI devices. The three
factory-installed terminators on the host adapter
are located below the internal SCSI connector, as
shown in this diagram:
The table below shows how termination should be
set for the three possible SCSI device and host
adapter configurations.
Devices Connected to
Host Adapter
Internal devices only
(host adapter at end of cable)
External devices only
(host adapter at end of cable)
Internal and external devices
(host adapter in the middle)
Host Adapter
Terminators
All three installed
All three installed
All three removed
3
Advertisement
Table of Contents
