Fcc Compliance Statement - Adaptec AHA-1510A Installation Manual

At-to-scsi host adapter

Hide thumbs Also See for AHA-1510A:

User manual (62 pages)

Table Of Contents

Table of Contents

This equipment has been tested and found to comply with the lim-

its for a Class B digital device, pursuant to Part 15 of the FCC

rules. These limits are designed to provide reasonable protection

against harmful interference in residential installations. This

equipment generates, uses, and can radiate radio frequency

energy, and if not installed and used in accordance with the

instructions, may cause harmful interference to radio communica-

tions. However, there is no guarantee that interference will not

occur in a particular installation.

If this equipment does cause interference to radio or television

equipment reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Move the equipment away from the receiver

• Plug the equipment into an outlet on a circuit different from

that to which the receiver is powered

• If necessary, the user should consult the dealer or an experi-

enced radio/television technician for additional suggestions

CAUTION: Only equipment certified to comply with Class B (com-

puter input/output devices, terminals, printers, etc.) should be

attached to this equipment, and must have shielded interface

cables.

Finally, any changes or modifications to the equipment by the user

not expressly approved by the grantee or manufacturer could void

the user's authority to operate such equipment.

Each AHA-1510A host adapter is equipped with an FCC compli-

ance label which shows only the FCC identification number. The

full text of the associated label follows:

This device complies with part 15 of the FCC rules. Oper-

ation is subject to the following two conditions: (1) this

device may not cause harmful interference and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

Adaptec, Inc.

691 South Milpitas Boulevard

Milpitas, CA 95035

Adaptec and the Adaptec logo are registered trademarks, and AHA

is a trademark, of Adaptec, Inc.

AT and OS/2 are registered trademarks of International Business

Machines Corporation. NetWare is a registered trademark of

Novell, Inc. Unix is a registered trademark of Unix System

Laboratories.

Printed in Singapore

Stock No: 510399-00 Rev. A KL 4/93

Information subject to change without notice.