About Cmd6-Multimeter Mode Setup - Texas Instruments CBL Manual Book

About CMD6—Multimeter Mode Setup
CMD6 Operations
sets up the CBL to use
CMD6
Multimeter mode only works on one of these two channels at a time. The
first element in the list must be a 6 to designate
List Syntax
{6,set_reset,operation}
Note: Pressing M lets you use the CBL in Multimeter mode as a
stand-alone device without requiring setup commands from the
calculator.
Set/Reset
This parameter lets you set or reset the Multimeter mode. (Default:
0 Restore to Communications mode
Set to Multimeter mode
1
When the CBL is in the Multimeter mode:
¦
CMD6
¦
Active channel defaults to
¦
Sample time defaults to 0.5 seconds.
¦
Trigger defaults to 1 Volt on the rising (+ +) edge with the
corresponding default trigger threshold for period and frequency.
¦
Result of the sample is displayed, but is not available for retrieval by
a calculator. This prevents overwriting collected data from
Communications mode.
Operation
This parameter selects the multimeter operation to measure. (Default:
1 AutoIDENT
Note: If
Voltage, 0 to 5 Volts
2 Voltage measurement
3* Current measurement
4 Resistance measurement
5 Period
6 Frequency
7** Meters
8** Feet
* Based on voltage conversion on Vin of 1V = 1A.
**Meters or feet apply only to the ultrasonic channel.
52 CBLé System Guidebook
is the only supported command.
is not active, the operation defaults to
AutoIDENT
or the
CH1 SONIC
.
CH1
channel as a multimeter.
CMD6 .
(„10 Volts)
(„10 Amps)
(1 Kohms to 100 Kohms)
(0.000004 sec to 50 sec)
(0.02 Hz to 250 KHz)
1 )
1 )