Texas Instruments CBL Manual Book page 26

Understanding CBL Commands
Example
Assume the CBL receives two one-parameter commands as successive
lists as shown by the following:
:{1}→ → L:Send(L)
:{3}→ → L‚:Send(L‚)
The CBL interprets the first list ({1}) as a Channel Setup command and
performs the following default operations:
1. Selects
2. Uses
active. All other
As previously noted,
CBL before data collection begins.
The CBL interprets the second list ({3}) as a Sample and Trigger Setup
command and performs the following default operations:
1. Sets Sample Time to 0.5 seconds, Number of Samples to 1, Trigger
Type to Manual, and Trigger Channel to 1. All other
default to 0 and are not active. (
2. Collects one sample when N is pressed (the
indicator blinks, and then
There are many more default parameters than those listed above. The
predefined settings will become more clear as you read about each of
the commands starting on the next page. On the following pages, default
parameters are shown in boldface for each of the command descriptions.
26 CBLé System Guidebook
CH1 to collect data.
AutoIDENT values if active, and voltage (0 to 5 Volts) if not
CMD1
CMD3
(Continued)
parameters default to 0 and are not active.
must be the last setup command sent to the
is lit in the display.)
READY
DONE is lit in the display).
CMD3 parameters
SAMPLING