Chapter 3: Using The Cbl System - Texas Instruments CBL Manual Book

Chapter 3: Using the CBL System

This chapter describes how the CBL is set up and controlled by commands
sent from a connected calculator. Parameter descriptions are provided for each
of the commands.
Chapter Contents
What a Typical Program Might Include
About Automatic Probe Identification (
Understanding Modes
Understanding CBL Commands
About CMD0-All Clear
About CMD1-Channel Setup
About CMD2-Data Type and Display Setup
About CMD3-Sample and Trigger Setup
About CMD4-Conversion Equation Setup
About CMD5-Data Range Setup
About CMD6-Multimeter Mode Setup
About CMD7-Request Status
.........................
.........................................
................................
.......................................
.................................
..............................
.........................
.................................
CBLé System Guidebook
)
AutoIDENT
............
....................
.......................
.....................
20
21
22
24
27
28
36
39
47
49
52
54
19