Inepro IP Card Reader Work Instruction page 15

Hardware Installation
2) Connect the USB cable to the PC you installed the software on
and the programmer unit.
3) Connect the black connector of the flat cable to the programmer
unit in such a way that the red side of the cable is on the left side
(this is the same side as pin 1 on the diagram on the
programmer). The cable will be running away from the
programmer unit.
Make sure you fit the cable correctly as it can fit in more then
one way! Failing to do so may result in a defective programmer unit
or a defective Interface board!
Repairing the resulting problems will not be covered by the
guarantee!
Connect the other end with the red side of the cable to the closest
short edge of the connector board, the connector should only fit in
one way, with the plastic rims gliding along the socket.
10