V-ZUG Combair V2000 Operating Instructions Manual page 42

8 Care and maintenance
Cleaning the door glass
▸ Lay the appliance door on a clean, flat surface
(covered e.g. with a tea towel) with the handle
facing down.
– Make sure the handle does not come into
contact with the surface.
▸ Lean against the appliance door.
▸ Gently push the outer glass 1 and raise it
slightly up and away from the hinges.
▸ Remove the intermediate door glass seal 2.
▸ Gently push the middle door glass 3 and raise
it slightly up and away from the hinges.
▸ Clean the glass panels and dry well.
▸ Reassemble the glass panels as follows: Insert
the middle door glass 3 into the door frame
and gently push it back towards the hinges.
– The markings on the glass must be legible.
▸ Reinstall the intermediate door glass seal 2.
▸ Insert the outer door glass 1 into the door
frame and gently push it back towards the
hinges.
– The outer door glass 1 can only be put back
if positioned correctly with the shiny surface
on the outside.
8.4 Cleaning the door seal
▸ Clean the door seal with a soft cloth dampened with water, but do not use any clean-
ing agent.
▸ Dry with a soft cloth.
42
1
2
3
2
3
1