Electrical Kit Installation; Connecting The Motor And Operating; Switch; Installing The Ignition Interlock - Dometic Oasis Elite 975 Series Installation & Operation Manual

Electrical Kit Installation

6. Place and tighten the screws through the bottom
mounting holes into the RV.
7. Secure the awning with a #6 X 1/2 in. TEK screw
(installer supplied) on each end of the awning rail,
approximately 6 in. (15 cm) from the awning bracket
edge.
7 Electrical Kit Installation
This section describes how to install electrical
components such as the motor and operating switch,
the LED light switch, and the ignition interlock.

WARNING: IMPACT, CRUSH, OR PROJECTILE
HAZARD. Failure to obey these warnings
could result in death or serious injury:
• Make sure the ignition interlock is working correctly
before traveling with the RV. If the awning responds
to the switch with the ignition in the ON position,
accidental operation during transit could occur.
The awning must be disabled, then serviced by a
qualified technician.
• Do not attempt transport with an awning motor that
has been damaged from an impact. Otherwise, the
awning could extend quickly and unexpectedly,
becoming a projectile during transit. If the awning
has been damaged, contact a licensed or certified
technician for repair.

WARNING: FIRE OR ELECTRICAL SHOCK
HAZARD. Failure to obey these warnings
could result in death or serious injury:
Before drilling or cutting into RV, make sure there
are no obstacles (wires, pipes, etc.) inside the
RV's roof, floor, or walls. Turn off the gas supply,
disconnect the 120 VAC power from the RV, and
disconnect the positive (+) 12 VDC terminal from
the supply battery .
NOTICE: Failure to obey the following notices may
cause damage to the product:
• Always seal the wiring against weather and
moisture where it enters the RV's walls, roof, or floor.
Otherwise, water leakage could occur.
• Use a grommet or heat shrink tubing wherever wiring
passes through the RV wall.
10
• Do not pinch the wiring or allow it to rub against
sharp edges. If the wiring is damaged, it must be
replaced by a qualified service technician.
• Do not expose the LED switch to weather, extreme
temperatures, or long hours in direct sunlight.
7.1 Connecting the Motor and
Operating Switch
1. Pull the motor wiring through the wiring hole and
grommet, and connect it to the appropriate wiring
inside the RV.
2. Make the electrical connections inside the RV per
the instructions supplied with your Dometic Control
Switch Accessory.

7.2 Installing the Ignition Interlock

1. Install the ignition interlock per the instructions
supplied with the ignition interlock kit or an optional
control kit such as Power Awning Pro or WeatherPro.
2. Verify the ignition interlock is working correctly:
a. Turn the ignition to the ON position.
b. Attempt to operate the awning.
If the awning does not respond, the ignition interlock is
operating properly.
If the awning operates:
1. Close the awning.
2. Disconnect the awning from the power source.
3. Have the ignition interlock repaired by a qualified
service technician.

7.3 Installing the LED Light Switch

An LED light switch (installer supplied) is required for
awning models equipped with an LED light strip.
If the awning does not have an LED light strip, skip
I
this section and proceed to "Post Installation" on
page 11.
1. Find a suitable location for the LED switch.
2. Inside the RV, route the wiring to the general location
Oasis Elite 975 Series
EN