Connect The Inlet Hose - Hanseatic HG5544F63602EW User Manual

Connect the inlet hose

NOTICE
Risk of damage!
The appliance is designed for a water
pressure of 0.4 to 10 bar (0.04 to 1.00
MPa). Water must always be able to run
freely into the dishwasher, otherwise
this can damage the appliance.
If the water pressure is higher than
■
this, install a pressure reducer.
If in doubt, enquire about the wa-
ter pressure with the water supply
company.
Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
Ensure that the inlet hose is not
■
kinked and is carefully connected.
Do not cut through the inlet hose.
■
It contains electrical components.
If the inlet hose is damaged,
have it repaired by a specialist
("Service" see page EN-33).
Do not use old or previously installed
■
inlet hoses.
3
For water supply, you need a water tap with
a ¾ inch screw connector.
Union nut with aqua stop
Installation, connection and initial commissioning
Union nut
(23)
1. Screw the union nut of the inlet hose of
the connection for the appliance (23) tight.
¾ inch
Inlet hose
2. Screw the inlet hose's union nut with aqua
stop to the tap hand-tight.
3. Check that the connection to the water
tap is sealed. Turn on the water tap slowly
and ensure that no water is escaping.
Then close the tap again.
Page EN-27