Advertisement
(In-line profile A)
(In-line profile A)
(Door panel B)
(Door panel B)
Using a metal scriber, mark the vertical profile profile at the end
9
of the glass. The glass return panel can be moved backwards or
forwards in the return profile, but the glass must be inside the
vertical wall profile by at least 5mm along its entire height.
Put the brackets to one side and use the suction glass lifters
1 1
to remove the glass return panel. Remove the horizontal return
profile; unscrew and remove the vertical wall profile.
Drill 7mm holes where marked on the wall; insert Rawl plugs.
Cut the vertical wall profile at the mark made earlier; file
smooth.
(C)
(C)
The Majestic Shower Company Limited
One North Place, Edinburgh Way, Harlow Essex
CM20 2SL England,
The end of the glass needs to be flush with the end of the
10
floor profile at the bottom, you may need to shorten the
bottom profile.
Disassemble two glass-to-wall brackets, being careful not to
damage the faceplates. With the clear plastic gaskets inserted
and wall screw plates facing inwards, align the brackets
centrally to the holes in the glass return panel; hold them in
place and mark the screw holes.
Run a bead of silicone along the wall side of the vertical wall
12
profile, and screw it tightly into place. Loosely screw the glass-
to-wall brackets to the wall.
Telephone + 44 (0) 8448 001 500
Facsimile + 44 (0) 1279 635 074
info@majesticshowers.com www.majesticshowers.com
Advertisement
