Advertisement
When you have determined how much to cut off each floor
profile, trim the square end and file smooth.
When measuring the cut profiles, always measure
from the mitre tip to the square ends.
(In-line profile A)
(In-line profile A)
(Door panel B)
(Door panel B)
Measure the width of the in-line profile A and the width of the
5
glass door panel B in mm and write the results into the boxes
below. Use the formula A + B + 8 to calculate C.
A
+
400
+
Example
Insert the 10mm spacer into the horizontal return profile, and
7
use it to align the vertical wall profile. Push the mitred ends
together, and use a spirit level to ensure the wall profile is plumb
vertical.
Mark the screw holes; remove the vertical wall profile. Drill
4.5mm holes; insert Rawl plugs.
(C)
(C)
B
D
+
8 =
400
+
808
8 =
The Majestic Shower Company Limited
One North Place, Edinburgh Way, Harlow Essex
CM20 2SL England,
Wall
Profile
(5 mm) (5 mm)
Floor profile
(In-line profile)
Make a mark on the floor Cmm along the wall. Place the inside
6
of the horizontal return profile outside the mark, perpendicular
(In-line profile A)
to the wall. Ensure the mitred end is pushed into the corner,
tape the profile into place and mark its position.
(Door panel B)
At this point, double check the measurements of the door and
in-line panel to make sure the gap is correct at the front of
the unit.
Reposition the vertical wall profile, and insert the top and bottom
8
screws to hold it place. Insert a rubber strip into the horizontal
return profile. Using the suction glass lifters, lift the glass return
panel into the profile.
Make sure the return panel is plumb vertical; pack it up with 3"
rubber strips if necessary, taking note of their positions. Do not
use more than three strips of rubber under the panel.
Telephone + 44 (0) 8448 001 500
Facsimile + 44 (0) 1279 635 074
info@majesticshowers.com www.majesticshowers.com
Glass
C
C
Floor
(C)
(Door panel)
(Return profile)
Advertisement
