Advertisement
Door Panel
Door Panel
Hinge
Hinge
packer
packer
90°
Position the hinges on the fixed panel centrally in their slots and
29
use a set square to ensure they are square to the edge of the
glass; the gaskets should be neat and flush, and the end of the
glass door should not protrude beyond the hinges. tighten the
Allen bolts.
With gaskets inserted, loosely screw the hinges and faceplates
31
together through the glass door panel slots.
Adjust the door so it is level with the two glass inline panels; the
gaskets should be neat and flush, and the end of the glass door
should not protrude beyond the hinges. Tighten the Allen bolts.
Fixed Panel
Fixed Panel
90°
90°
90°
Hinge
Hinge
packer
packer
Fixed Panel
Hinge packer
The Majestic Shower Company Limited
One North Place, Edinburgh Way, Harlow Essex
CM20 2SL England,
Door Panel
Hinge
packer
90°
Steps 25-26 require one person to support the glass
30
door panel at all times, while another person must be
inside the enclosure with faceplates, gaskets and screws. Insert
a black rubber hinge packer in the door hinge slots as shown.
Position the door mounting blocks on the tray or floor. Using the
suction glass lifters, lift the glass door panel onto the mounting
blocks; be careful not to chip the edges of the glass against
each other.
The 1936 door-to-glass seal (2) should be cut
32
into three pieces to fit vertically above,
between and below the hinges on the end of
the door.
Open the door outwards and slide the
sections into place on the door. If necessary,
adjust the door on its hinges so that it closes
correctly onto the return panel seal.
Telephone + 44 (0) 8448 001 500
Facsimile + 44 (0) 1279 635 074
info@majesticshowers.com www.majesticshowers.com
Door Panel
Door Panel
Fixed Panel
Hinge packer
Hinge packer
90°
Hinge
packer
2
Advertisement
