Advertisement
x
x
Measure the length of the outside of the horizontal return profile
17
Xmm, and make a mark at this point on the opposite wall. Place
the outside of the horizontal inline profile inside the mark,
perpendicular to the wall. Ensure the mitred end is pushed into
the corner, tape the profile into place and mark its position.
Double check that the out side of the in-line profile
aligns with the end of the glass return panel.
Reposition the vertical wall profile, and insert the top and
19
bottom screws to hold it place. Insert a rubber strip into the
horizontal inline profile. Using the suction glass lifters, lift the
glass inline panel into the profile.
Make sure the glass inline panel is plumb vertical and level with
the return panel; pack it up with 3" rubber strips if necessary,
taking note of their positions. Do not use more than three strips
of rubber under the panel.
x
x
The Majestic Shower Company Limited
One North Place, Edinburgh Way, Harlow Essex
CM20 2SL England,
Insert the 10mm spacer into the horizontal inline profile, and use
18
it to align the second vertical wall profile. Push the mitred ends
x
together, and use a spirit level to ensure the wall profile is plumb
vertical.
Mark the screw holes; remove the vertical wall profile. Drill
4.5mm holes; insert Rawl plugs.
Disassemble the remaining two glass-to-wall brackets, being
20
careful not to damage the faceplates. With the clear plastic gaskets
inserted and wall screw plates facing inwards, align the brackets
centrally to the holes in the glass return panel; hold them in place
and mark the screw holes.
Telephone + 44 (0) 8448 001 500
Facsimile + 44 (0) 1279 635 074
info@majesticshowers.com www.majesticshowers.com
x
Advertisement
