Advertisement
Run a bead of silicone along the base of the horizontal return
13
profile, and reposition it on the tray or floor where marked; use
the 10mm spacer to ensure it is aligned with the vertical wall
profile and push the mitred ends together; tape into position.
Remove the 10mm spacer and apply a small amount of silicone
into the corner joint. Reinsert the noted rubber strips into the
horizontal return profile.
Using the suction glass lifters, replace the glass return panel into
15
the silicone-lined profiles. Make sure it is level with the open end
of the profile.
The Majestic Shower Company Limited
One North Place, Edinburgh Way, Harlow Essex
CM20 2SL England,
As shown, run beads of silicone along the inside of the vertical
14
wall profile and the horizontal return profile.
x
Loosely fix the faceplates to the glass-to-wall brackets
16
through the holes in the glass return panel; fully tighten the
wall screws.
Ensure the glass return panel is plumb vertical, then fully
tighten the glass-to-wall bracket faceplates.
Telephone + 44 (0) 8448 001 500
Facsimile + 44 (0) 1279 635 074
info@majesticshowers.com www.majesticshowers.com
x
Advertisement
