Table of Contents
Advertisement
2.COPY FUNCTIONS
5
Press [START] to start copying.
To stop or resume copying, press [CLEAR/STOP] during copying.
Press [OK] or [CANCEL] according to the message displayed on the LCD screen.
When you copy loading originals from the Reversing Automatic Document Feeder (RADF):
If there are more originals, place the next ones, select "SCAN NEXT" using
more originals, select "FINISHED" using
If originals remain on the Reversing Automatic Document Feeder after pressing [FINISHED] on the CONTINUE
SCAN screen, remove all the originals. Leaving them may cause a paper jam.
When the copying has finished, press [FUNCTION CLEAR] to clear the set copy functions and return to the main
screen (Copy).
If the paper source runs out of paper, an error message is displayed on the LCD screen and copying stops. Load
paper. The equipment automatically resumes copying after approx. 3 seconds have passed.
The receiving tray can hold up to 100 sheets. If the excessive paper error occurs, the lamp blinks and an error
message is displayed on the LCD screen. Remove the paper from the tray and press [START] to resume copying.
When you use overhead transparencies, remove them one by one every time they are ejected. Otherwise, they
could be curled and not be good for projection.
36 Basic Copy Procedure
or
and press [OK]. (Only when "CONTINUE SCAN" is set to "ON")
or
and press [OK]. If there are no
Advertisement
Table of Contents
