Terminal Installation Using The Optional Mounting Kits; Terminal Installation Using The Magnetic Mounting Kit - Hughes EchoStar Mobile 4500 Install Manual

Hide thumbs Also See for EchoStar Mobile 4500:

Table of Contents

Terminal Installation using the Optional Mounting Kits

Using the Magnetic Mounting Kit, the Hughes 4500 Terminal can be installed on

any horizontal metallic surface (e.g. on the top of a vehicle).

Figure 4: Magnetic Mounting Kit Installation

All the parts included in the Mounting Kit (one plate with two magnets, washers

and screws) should be used and positioned as shown in the following figures

and described below:

1. Place the plate so its four holes must face the equivalent ones on the

Terminal. The holes on each side have the same dimensions

2. Position all the washers touching the head of each screw

3. Tighten all the screws so that washers are compressed

Note: Please note that the torque specification for the screws is 1~1.25 Nm

(9.0~11.0 lbf in).

4. Decide where you are going to install the Terminal

5. Place the assembly so the magnets are on top of the horizontal surface

6. Ensure the Terminal is stable, and it is not moving

7. Refer to the 3004339-0001 Hughes Quick Start Guide for more details to

install the SIM and bring up the Terminal

8. Refer to the User Guide for further details.

Chapter 1 • Installation Instructions

H63998 Revision B

Table of Contents