Speakers - HP Elite Folio Maintenance And Service Manual

To insert the battery, reverse the removal procedures.

Speakers

To remove the speakers, use this procedure and illustration.
Table 6-2 Speakers description and part number
Description
Speakers
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the pen (see
3. Remove the bottom cover (see
4. Remove the battery (see
Remove the speakers:
1. Disconnect the right speaker cable from the system board (1).
NOTE:
speakers.
2. Remove the antenna cable from its routing path near the right speaker (2).
NOTE:
speaker cable.
3. Disconnect the left speaker cable from the system board (3).
4. Remove the right speaker cable from the channel below the system board (4).
5. Remove the two Phillips M1.4 × 1.2 screw (5) from each speaker.
Pen on page
Bottom cover on page
Battery on page
If tape is holding the cables in place, gently pull up and reuse the tape when reassembling the
You must pull the WWAN antenna cables and tape up and left before you can remove the left
Preparation for disassembly on page
28).
30).
31).
Spare part number
M35259-001
28).
Component replacement procedures 33