6.
Remove the speakers from the computer (6).
Reverse this procedure to install the speakers.
NOTE:
When installing the speakers, be sure rubber grommets are installed in the screw holes in the
speakers.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 6-3
Touchpad description and part number
Description
Touchpad
Touchpad cable (included in Cable Kit)
Before removing the touchpad, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the pen (see
3.
Remove the bottom cover (see
4.
Remove the battery (see
Remove the touchpad:
1.
Disconnect the touchpad cable from the touchpad ZIF connector (1).
2.
Gently pull up to release the keyboard cable from the adhesive that secures it to the top of the touchpad
(2).
NOTE:
keyboard cable.
34
Chapter 6 Removal and replacement procedures for authorized service provider parts
Pen on page
Bottom cover on page
Battery on page
To prevent damage to the cable, be careful not to use too much force when releasing the
Preparation for disassembly on page
28).
30).
31).
Spare part number
M35286-001
M35257-001
28).