Access Control -- Ip Address Configuration - D-Link DWR-956M User Manual

Access Control -- IP Address Configuration

This is used to add a firewall rule.
Protocol: The protocol for the firewall rule. This can be HTTP, TELNET,
FTP, SAMBA, ICMP, TFTP, SNMP, SSH, TCP or UDP.
Choosing the HTTP, TELNET, FTP, TFTP, SSH, TCP or UDP options displays other
options on the page, and these are documented below.
Access Control: The access control interface for the firewall rule.
IP Protocol Type: The protocol type for the firewall rule.
This can be IPv4, IPv6 or IPv4&6.
Enable: Whether to enable or disable the firewall rule. Tick this to enable
the firewall rule. The default is un-ticked.
Source IP: The source IP address(es) for the firewall rule.
Enter a single IP address for the source address, or enter a range of
addresses in the beginning and end boxes.
Action: The action for the firewall rule. This can be ACCEPT or DROP.
Protocol: HTTP, TELNET, FTP, TFTP, SSH, TCP or UDP
Port: The port number for the firewall rule.
Click Back to go back to the previous page, click Apply to apply the settings and
click Refresh to refresh the page.