L2Tp; L2Tp Lac Tunnel Setting - D-Link DWR-956M User Manual

L2TP

This is used to set basic L2TP settings.

L2TP LAC Tunnel Setting

This is used to set basic L2TP tunnel settings.
L2TP LAC Tunnel Settings
Connection Name: The connection name for the L2TP tunnel.
Enable: Whether to enable or disable the L2TP tunnel. Tick this to enable the L2TP
tunnel. The default is un-ticked.
Tunnel Name: The tunnel name for the L2TP tunnel.
Tunnel Interface IP Mode: This can be Static or Dynamic. The default is Dynamic.
Tunnel Interface IP: The IP address to listen on for the L2TP tunnel. Option only
available when Tunnel Interface IP Mode is set to static.
NAT: Whether to enable or disable Network Address Translation. Tick this to enable
NAT. The default is un-ticked.
Default Route: Allow all LAN-WAN to be directed via the VPN.
Authentication Type: Auto, PAP or CHAP. The Authentication Type of the LAC tunnel.
LNS Addr Mode: The LNS addressing mode. This can be FQDN or IP. Default is FQDN
LNS Domain Name/IP: The LNS FQDN/IP address to use with the L2TP tunnel.
User Name: The username for the L2TP tunnel.
Password: The password for the L2TP tunnel.
Max Redial: Amount to re-dail if connection is not successful. Min 1, Recommended 3-5.
Click Apply to apply the settings and click Refresh to refresh the page.
L2TP LAC Rule List
View the L2TP Rule created