Haier HP200S1 Operation And Installation Manual page 21

Installation introduction
Electrical connections
Correct
Alimentation
Interconnection
cable
cable
Description
Alimentation cable
Interconnection cable
Off-peak power signal wire
Tank temperature sensor
Display panel signal wire
Connecting the external unit cables:
a)Remove the electric cover.
b)Connect the external unit cables, according to the wiring diagrams .
c)Connect the display panel signal
power signal wire .
d)After connection, you must use the fixing board to press the cable.
Fixing board should be pressed against the outer sheath of the cable.
e)Install the electric cover.
Electrical cover
Terminal block
Earth connection
Fixing board
Availability
not supplied
supplied
supplied
supplied
supplied
wire, the tank temperature sensor and Off-peak
21
N
L N L
Cable
3*2.5mm²
3*1.5mm²
H03VVH2-F
2*0.75mm²
4*0.2mm²
shielded – UL2464
4*0.2mm² shielded – UL2464
Terminal block
Earth connection
Fixing board
Tank temperature
sensor
Display panel
signal wire
Off-peak power
signal wire
(2*0.75mm2 )
Type
H05RN-F
H05RN-F