Table of Contents
Advertisement
1-19-3. Notes on Disconnecting/Connecting
the Coaxial Cable
The coaxial cables are used for this unit.
The following notes are required for disconnecting/
connecting the coaxial cables.
Notes on Disconnecting
Do not attempt to remove by pulling the cable. Be sure to
hold the plug to remove.
OK
Hold the plug to
remove.
Notes on Connecting
. Hold the plug, and connect the coaxial cable to the
connector vertically.
. Press the plug into the connector by small turning to the
left and the right.
Hold the plug to connect
Connecting connector
WLL-RX55
NG
Do not attempt to
remove by
pulling the cable.
1-19-4. Note on Handling the Fine Pitch
Coaxial Cables
The fine pitch coaxial cables are used in this unit.
Be careful not to bend the fine pitch coaxial cables. This
shortens the wire life.
This unit may not operate normally if a foreign material
such as dust is attached on the connecting surfaces of the
fine pitch coaxial cables.
Therefore, it is recommended to disconnect/connect the
fine pitch coaxial cables in a clean place (dustless loca-
tion).
Notes on Disconnecting
. Be sure to turn off the power of this unit before discon-
necting the fine pitch coaxial cable.
. Do not attempt to remove the fine pitch coaxial cable by
pulling the cable. Be sure to hold the connector to
remove the fine pitch coaxial cable.
n
If the cable is pulled up and down or right and left, the
portion in the figure will be damaged.
OK
Hold the connector to remove.
Do not attempt to remove by pulling
NG
the cables.
Easy to damaged.
1-37 (E)
Advertisement
Table of Contents
