Table of Contents
Advertisement
3. Disconnect all the harnesses and flexible card wires
from the rear assembly as shown in the figure.
m
. When disconnecting the coaxial cable, do not
attempt to remove by pulling the cable. Be sure to
hold the plug to remove.
. Be careful not to bend the flexible card wires. This
shortens the wire life.
Wiring stoppers
Rear assembly
Hold the plug to
OK
remove.
WLL-RX55
Do not attempt to
NG
remove by pulling
the cable.
4. Reattach the rear assembly in the reverse order of
removal.
m
. When connecting the coaxial cable, hold the plug
and connect the coaxial cable to the connector
vertically.
Press the plug into the connector by small turning to
the left and the right.
Hold the plug to connect
Connecting connector
. Bind again the cables and the harnesses that were
originally bound with a wiring stopper.
. When reattaching the rear assembly, tighten the five
screws sequentially in accordance with the figure.
1 B3 x 6
2 B3 x 6
3 B3 x 6
4 B3 x 6
5 B3 x 6
1-7 (E)
Advertisement
Table of Contents
