Table of Contents
Advertisement
Hardware Preparation and Installation
2.6.2
Removing an SFP/SFP+ Module
Procedure
In order to remove an SFP/SFP+ module, proceed as follows.
1. Remove any connected cable from SFP/SFP+ module.
2. Open the SFP/SFP+ latch. Note that the latch mechanism of your SFP/SFP+ module
may be slightly different compared to the latch shown in the following figure.
RTM-ATCA-736x-10G Installation and Use (6806800P29G)
41
Advertisement
Table of Contents
Need help?
Do you have a question about the RTM-ATCA-736x-10G Series and is the answer not in the manual?