Advertisement
Product Specifications
• Approvals CE, FCC, IC
• Wireless Frequency 2.4GHz, IEEE 802.15.4,
using AES 128-bit encryption
• AA Lithium Energizer L91 Rated 1.5 VDC, 3 Ah
NOTE: Replace Battery With Energizer L91
batteries only. Use of another battery may
present a risk of fire or explosion.
CAUTION: Risk of fire and burns. DO NOT
recharge, disassemble, heat above operating
temperature or incinerate. Keep battery out of
reach of children and in original package until
ready to use. Dispose of used batteries promptly.
• Battery Life 2+ years (45,0000 cycles)*
*All battery life claims are approximate and based on a
set configuration profile. Battery performance is based
on pre-defined system settings such as battery chemistry
and battery model used, credential presentation settings
(LED/buzzer), UHF polling period, UHF status intervals,
and operations per day. Actual battery performance
will vary and depends on the factors above.
• HID
multiCLASS SE
technology Credentials Supported
®
®
• High Frequency (13.56 MHz)
» HID iCLASS
®
» HID iCLASS SE
(SIO-enabled)
®
» HID iCLASS
Seos™
®
» HID MIFARE
SE
®
» HID DESfire
EV1 SE
®
» MIFARE CLASSIC
» DESfire
EV1
®
• Low Frequency (125 kHz)
HID Prox
, AWID, EM4102, ioProx
®
• NFC/BLE* Mobile – enabled credentials
Reader is compatabile with HID Mobile
Access version 3.76 and later using mobile
devices with BLE version 4.2 and later
WARNING
FCC Statement
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Operation with non-approved equipment is likely to result in interference to radio
and TV reception. The user is cautioned that changes and modifications made
to the equipment without the approval of manufacturer could void the user's
authority to operate this equipment. To comply with FCC and Industry Canada RF
radiation exposure limits for general population, the module must be installed to
provide a separation distance of at least 20cm from all persons and must not be
colocated or operating in conjunction with any other antenna or transmitter.
This module is labeled with its own FCC ID and IC Certification Number. If the
FCC ID and IC Certification Number are not visible when the module is installed
inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. In that case,
the final end product must be labeled in a visible area with the following:
Environmental
• Operating Temperature 32° to 150° F (0° to 66° C)
• Humidity 30° C at 95% +/- 5%
• Strike Bodies ES100 15/16 For Indoor Use ONLY
• ES100 Reader For Indoor Use ONLY
UL Listings
• UL 1034 (CVXY.BP7059)
» Static Strength 1,500 lbs
» Dynamic Impact 70 ft-lbs
» Endurance 250,000 cycles
• UL 10C 3 Hr (GXAY(7);R9483)
• UL 294
» Destructive Attack Level 1 (No attack test)
» Line Security Level I (No Line Security)
» Endurance Level IV (100,000 cycles)
» Standby Power Level I (No secondary power source)
• Windstorm (ZHEM.R27043)
Safety and Emissions
• FCC 47CFR Part 15, subpart C
• IC RSS-102
• RSS-210
• RSS-247
• RE Directive 2014/53/EU EN 301 489-1, EN 301 489-3,
EN 300 440, EN 300 330, EN 300 328, EN 62368-1, EN 62479
NOTE: The effective operational range/distance (RF performance) of any wireless device
is dependent on a variety of factors including but not limited to metalized reflective
surfaces, absorbing materials, building materials, coexistence with nearby transmitters,
adjacent band harmonics, etc. For example, if the application requires the Aperio ES100
Reader to communicate though glass with metalized (solar) film applied to reach
the hub, the maximum distance may be reduced to as much as 50 feet (15 meters)
depending on these factors. Please perform an RF site survey before installation.
Contains FCC ID: VC3-R100V3
Contains IC: 7160A-R100V3
IC Statement
This device complies with Industry Canada license-exempt RSS
standards(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation.
Conformité aux normes IC
Cet appareil est confrome avec Industrie Canada exempt de license RSS
standard(s). Son fonctionnement est souimes aux deux conditions suivantes:
(1) cet appareil ne peut causer d'interférences, et
(2) cet appareil doit accepter toute interference, y compris des interférences
qui peuvent provoquer un fonctionnement indésirable du périphérique.
CE Declaration of Conformity
content.assaabloyusa.com/doc/AADSS1176114
HES ES100 Install Instructions Appendix: 2
Advertisement
