Installation Of The Female Ground Connector; Installation Of Ferrites - JDS Uniphase OTU-8000 (EOTU8000E) User Manual

Installation of the Female
Ground Connector

Installation of Ferrites

Procedure for switching on
and off the OTU-8000
NOTE
The OTU-8000 cover panel clearly states the place of each wire to
connect above the male connector.
The OTU-8000 is equipped with a male ground connector. You need a
female clip (large: 6.3 mm / width: 0.8 mm), which will be set onto the
Male Ground connector, as described in the photo below.
Female ground
Fig. 23 Female Ground Connector
The OTU is delivered with 2 ferrites to set onto the 48V supply cable:
1 Open the ferrite
2 Make 1 turn of the cables around the ferrite
3 Close the ferrite
4 Repeat the process for the second ferrite if another supply cable is
used.
Fig. 24 Ferrite and cable
As the OTU-8000 has been designed to function permanently, no
switch on and switch off buttons are offered. Nevertheless, a specific
procedure is required if you really need to switch on or off the OTU-
8000.
Switching on the OTU-8000
1 Plug the 5-pin connector.
2 Wait that the led Stand-by indicates that the switching on procedure
is completed, (about 3 min.) (see
Switching off the OTU-8000
1 Keep pressing on the button Off for about 3 seconds to place the
OTU-8000 in Stand-by
2 Wait that the led Stand-by indicates that the switching off procedure
is completed, (about 30 seconds). For LEDs description, see
description" page 18.
3 Unplug the 5-pin connector.
User Manual 7OTU80050/01
Chapter 3 Installation of the OTU-8000
connector
Male ground
connector
"LEDs description" on page
Supply installation
18).
"LEDs
25