Symbols Used In This Manual; Symbols On The Power Tool; Important Safety Information - Flex RE 16-5 Original Operating Instructions

Contents
Symbols used in this manual . . . . . . . . . 16
Symbols on the power tool . . . . . . . . . . . 16
Important safety information . . . . . . . . . 16
Noise and vibration . . . . . . . . . . . . . . . . 19
Technical data . . . . . . . . . . . . . . . . . . . . 20
Overview . . . . . . . . . . . . . . . . . . . . . . . . 21
Instructions for use . . . . . . . . . . . . . . . . 22
Maintenance and care . . . . . . . . . . . . . . 26
Disposal information . . . . . . . . . . . . . . . 27
conformity . . . . . . . . . . . . . . . . . . . . . 27
Exemption from liability . . . . . . . . . . . . . 27

Symbols used in this manual

WARNING!
Denotes impending danger. Non-
observance of this warning may result in
death or extremely severe injuries.
CAUTION!
Denotes a potentially dangerous situation.
Non-observance of this warning may result in
injury or damage to property.
NOTE
Denotes hints on use and important
information.

Symbols on the power tool

Read the operating instructions to
reduce the risk of injury.
Wear protective goggles.
Wear ear defenders.
Disposal information for the old
tool (see page 27).
16

Important safety information

WARNING!
Before using the power tool, please read the
following and act accordingly:
- These operating instructions
- The "General safety instructions" on
the handling of power tools in the enclosed
booklet (leaflet no.: 315.915)
- The currently valid site rules and the
regulations for the prevention of accidents
This power tool is state of the art and has
been assembled in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may pose a danger to life and limb of the user
or a third party, or the power tool or other
items could be damaged. The power tool
may be operated only
- for its intended use,
- in perfect working order.
Faults which compromise safety must be
repaired immediately.
Intended use
The concrete planer RE 16-5 115 is designed
- for commercial use in industry and trade
- for planing formwork transitions and for
keying concrete surfaces
- for removing paint, plaster, remains from
tile and carpet adhesive on hard substrates
(hard plaster, concrete)
- for dry grinding and smooth finishing
concrete, plaster, screed, sandstone,
fireclay and tarmac
- for use with tools that are offered by FLEX
for these power tools and are authorised to
run at a speed of at least 6,300 rpm.
It is not permitted to use cutting discs, rubbing
discs, flap discs or wire brushes.
A class M dust extractor must be connected
when using this concrete planer
RE 16-5 115.
RE 16-5 115