Table of Contents
Advertisement
Select YES to continue using the scan function and
press the SET button to begin scanning.
If the wireless remote control function is operating on
all tuners that are powered on, a confirmation screen
does not appear, the transmitter is automatically set to
SLEEP, and scanning begins.
When all BANDS have been scanned, the scan
function is terminated.
5
Check the detected frequency candidate and press the
SET button.
Detected candidate reception channels (CH) and
frequencies are displayed alternately.
Check the displayed candidates and press the SET
button to finish.
This operation does not confirm the channel.
6
To use a confirmed channel, check that it is displayed
on the configured tuner or transmitter, then press the
SET button.
If the wireless remote control function is operating, the
transmitter GP/CH are also automatically set and
SLEEP is canceled.
If you want to use the empty channel of another
BAND, press the + or – button to select ANOTHER
BAND, the press the SET button and go back to step 5.
Notes
• If the power is on for both tuner 1 and 2, the band set on
tuner 1 is used for scanning.
The same band as on tuner 1 is also used on tuner 2. If
you would like to set different bands on tuner 1 and 2,
turn only one tuner on and use automatic scan/sync.
• The group that initiates a scan in this function is fixed,
and cannot be changed.
• If the receiving channel (CH) configured on the receiver
is a channel for which use with the wireless remote
control function is restricted on the transmitter side, the
UNMATCH screen appears.
In such cases, change the receiving channel on the
receiver. If you want to use the restricted channel, set
REMOTE to OFF in the transmitter's menu to release
the channel restriction, and manually configure the
transmitter's channel.
Using the active channel scan
function
This function scans for a Sony digital wireless frequency
from the frequency lists within the GP (group) selected
during the GP/CH selection function.
Required condition for the detection:
• Sony digital wireless signal
• Above the RF squelch level of the receiver
• The setting of the encrypted transmission function is
correct
• The audio codec mode settings match
1
Press the MENU SELECT button repeatedly until the
RX1/RX2 menu is displayed.
2
Press the + or – button repeatedly until the ACT CH
SCAN indication is displayed.
3
Hold down the SET button until the item to be set
flashes.
4
Press the + or – button repeatedly to select YES.
Scanning starts. When a Sony digital wireless
frequency is detected, scanning stops and the
frequency is displayed.
If you select NO, the scanning function will be
cancelled.
5
If you decide on that frequency after checking it out,
press the + or – button repeatedly to select SET, and
then press the SET button.
To search for another frequency, press the + or –
button repeatedly to select CONTINUE, and then
press the SET button.
Note
If a Sony digital wireless frequency within the group is not
found by the second try, scanning is cancelled.
Using the clear channel scan
function
This function searches for a channel that is not being used
by another wireless device or by a TV station. This
function makes it easy to find an available channel to allow
the wireless microphone to be used without interference.
The function searches for an empty channel among the
registered frequencies within the GP (group) selected by
the GP/CH selection function.
In addition to using the following procedure, you can also
set the POWER switch on tuner 1 or tuner 2 to ON while
holding down the + button to start the clear channel scan
function on the tuner that you turned ON.
1
Press the MENU SELECT button repeatedly until the
RX1/RX2 menu is displayed.
2
Press the + or – button repeatedly until the CLR CH
SCAN indication is displayed.
3
Hold down the SET button until the item to be set
flashes.
4
In the CLR CH SCAN indication, press the + or –
button repeatedly to select YES.
Scanning starts. When an empty channel is detected,
scanning stops and the frequency is displayed.
9
Advertisement
Table of Contents
