Changing The Settings On The Transmitter; Group/Channel Setting (Gp/Ch); Audio Attenuator Setting (Att); Low-Cut Filter Setting (Lcf) - Sony DWR-S03D Operating Instructions Manual

• Audio input level setting
• RF transmission power setting
• +48V power setting
• Battery level display setting
For details on the transmitter settings, see "Changing the
Settings on the Transmitter" on page 19.
Cancelling the Cross Remote
In the TX1/2 menu, select RF REMOTE, and then OFF.
Notes on the Cross Remote
The wireless remote control function on the receiver uses
the 2.4 GHz band and may thus be subject to interference
from other devices.
• When pairing fails ("Pairing fail" is displayed), carry out
pairing again. Successful communication between the
transmitter and the receiver has not occurred within a
given amount of time. Pairing may be harder to do when
another receiver is engaged in pairing nearby.
• When it becomes hard to use the remote control, the
remote control may be improved by switching the
wireless remote control function off, then on again in the
RF REMOTE display, then re-pairing with the
transmitter (change to a channel with less interference).
Changing the Settings on
the Transmitter
For details on menu operation, see "Basic menu
operations" on page 12.
You can change the settings on the transmitter that is
paired with this receiver using the RX1/2 menu or the
TX1/2 menu.
The following shows the US model display.
Receiver
Group/channel setting
This setting is set through the GP/CH indication of the
RX1/2 menu.
For details, see "Selecting the frequency band / group /
channel" on page 7.
Audio attenuator setting
When the input of the transmitter is set to MIC, the value
of the attenuator can be changed.
The attenuator values that can be selected depend on the
transmitter function.
Low-cut filter setting
The low-cut filter setting of the transmitter can be changed.
Note
The frequency selection depends on the transmitter
function.
Lock function setting
This disables the transmitter main unit POWER button and
locks settings so they cannot be changed. Doing so
prevents users from accidentally turning off the power.
Settings can be changed via Cross Remote from the
receiver even if the transmitter LOCK function is enabled.
19
Transmitter
(GP/CH)
(ATT)
(LCF)
(LOCK)