Using The Active Channel Scan Function; Using The Clear Channel Scan Function - Sony DWR-S01D Operating Instructions Manual

Using the Active Channel
Scan Function
This function scans for a Sony digital
wireless frequency from the frequency lists
within the GP (group) selected during the
GP/CH selection function.
Required condition for the detection:
• Sony digital wireless signal
• Above the RF squelch level of the
receiver
• The setting of the encrypted transmission
function is correct.
1
Press the MENU SELECT button
repeatedly until the RX1/RX2 menu is
displayed.
2
Press the + or – button repeatedly until
the ACT CH SCAN indication is
displayed.
3
Hold down the SET button until the
item to be set flashes.
4
Press the + or – button repeatedly to
select YES.
Scanning starts. When a Sony digital
wireless frequency is detected,
scanning stops and the frequency is
displayed.
If you select NO, the scanning function
will be cancelled.
5
If you decide on that frequency after
checking it out, press the + or
repeatedly to select SET, and then
press the SET button.
To search for another frequency, press
the + or – button repeatedly to select
CONTINUE, and then press the SET
button.
Note
If a Sony digital wireless frequency within
the group is not found by the second try,
scanning is cancelled.
Using the Clear Channel
Scan Function
This function searches for a channel that is
not being used by another wireless device
or by a TV station. This function makes it
easy to find an available channel to allow
the wireless microphone to be used without
interference.
The function searches for an empty channel
among the registered frequencies within the
GP (group) selected by the GP/CH selection
function.
In addition to using the following
procedure, you can also set the POWER
switch on tuner 1 or tuner 2 to ON while
holding down the + button to start the clear
channel scan function on the tuner that you
turned ON.
1
Press the MENU SELECT button
repeatedly until the RX1/RX2 menu is
displayed.
2
Press the + or
the CLR CH SCAN indication is
displayed.
3
Hold down the SET button until the
item to be set flashes.
4
– button
In the CLR CH SCAN indication,
press the + or
select YES.
Scanning starts. When an empty
channel is detected, scanning stops and
the frequency is displayed.
If you select NO, the scanning function
will be cancelled.
– button repeatedly until
– button repeatedly to
Setting the Receiving Channel 13