Table of Contents
Advertisement
Symptom
Meanings
Wireless remote
Pairing has not been established between the
control is not
transmitter and receiver.
possible.
The receiver is too far from the transmitter for
communication to occur.
The transmitter that was paired with the receiver
has been paired with another receiver.
The software version of the transmitter is not
suitable for use with this receiver.
The display is too
The display brightness is set to low.
dark.
"USB CONNECT"
The receiver is set to software update standby
appears on the
mode.
screen and
reception and
controls are not
possible.
Or there is no audio
output.
Remedy
Carry out pairing (see page 18).
Check the condition level. If it is low, decrease the
distance between the transmitter and the receiver.
Carry out pairing again with the transmitter that you
want to control.
Refer to the transmitter software compatibility table,
and confirm whether the software version of the
transmitter is suitable for use with this receiver (see
page 24). If it is not suitable, software update is
necessary. Contact your Sony service
representative.
Adjust the brightness of the display (see page 14).
Disconnect the USB device from the USB
connector.
Do not connect any USB devices to the USB
connector other than when updating the software.
23
Advertisement
Table of Contents
