Emerson CF765BQ01 Owner's Manual page 6

8. Make sure the grommet is properly installed in the
coupling cover, then slide the coupling cover on the
downrod until it rests on the motor housing. Place
the ceiling cover over the downrod. Be sure that the
ceiling cover and the coupling cover are both
oriented correctly (Figure 5).
9. Reinstall the hanger ball (Figure 6) on the downrod
as follows. Route the two 80" motor leads through
the hanger ball. Position the pin through the two
holes in the downrod and align the hanger ball so the
pin is captured in the groove in the top of the hanger
ball. Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball.
Loose setscrews could create fan wobble.
Please call Emerson
1-800-654-3545 if you have any questions
about installation and operation of this ceiling fan.
Ceiling Fan Assembly
technical support
(continued)
CEILING COVER
MOTOR COUPLING
COVER
MOTOR COVER
at
Figure 5
SETSCREW
CEILING COVER
Figure 6
6
PIN
DOWNROD
U.L. Model No.: CF765-1
DOWNROD
HANGER
BALL