Specifications - Evikon PluraSens E2638 Series User Manual

E2638-ETO
Specifications
Sensor type
Sampling method
Typical detection range
Maximum overload
Resolution / digital unit
Outputs scale
Response time T90
Sensor lifetime
Calibration interval
Signal update
Power supply
Power consumption
Analog outputs
Outputs assignment
Output scale width
Load resistance
Digital interface
Enclosure
Dimensions
CE marking
Operating conditions
According to 2014/30/EU and 2014/35/EU, EN 50491-4-1:2012
EN 61000-6-3:2020, EN 61326-1:2013(EMC, emissions)
EN 61000-6-1:2019, EN 61000-6-2:2019(EMC, Immunity)
EN 60079-29-1:2016, EN 60079-29-2:2015 and EN 60079-29-3:2014
-20...+50 °C, 15...90% RH non-condensing, 0,9...1,1 atm
NOTE The sensor may exhibit sensitivity to carbon monoxide, toluene and
0...20 ppm
100 ppm
0.1 ppm
0-200
< 120 s
24 VAC or 90...265 VAC as options
2 × 4-20 mA / 0-10 V, user settable
NOTE! for LCD version only output 1 is available
Recommended: 20-100% of the detection range
R < (Us - 2 V) / 22 mA for 4-20 mA
L
RS485, Modbus RTU protocol; No galvanic isolation
Grey ABS, wall mount, protection class IP65
(overall dimensions H140 × W145 × D55 mm)
4
Rev 10.03.2021
Electrochemical cell
0...100 ppm
Every 1 second
11...30 VDC,
OUT1 gas; OUT2 gas
> 10 × resolution
R > 250 kOhm for 0-10 V mode
L
H90 × W145 × D55 mm
Explosion-safe areas,
Non-aggressive atmosphere
other organic compounds
Diffusion
200 ppm
1 ppm
0-100
< 150 s
>2 years
6 months
< 2 VA