Evikon PluraSens E2638 Series User Manual page 19

E2638-ETO
257 /
0x0101
40258
259 /
0x0103
40260
261 /
0x0105
40262
262 /
0x0106
40263
263 /
0x0107
40264
264 /
0x0108 40265 RW
* – The new value is applied after restart.
** – Broadcast slave ID 0 can be used to assign a new ID to the instrument with an
unknown ID. When addressing by ID 0 the device shall be the only Modbus instrument in
the network. The device will not respond to the Master command when addressed by ID 0.
*** – This value is dynamic and not kept in EEPROM after a restart.
R Raw gas sensor data
Gas concentration,
R
gas units
0% value
RW
for analog output 1
100% value
RW
for analog output 1
0% value
RW
for analog output 2
100% value
for analog output 2
RO
bit[8]=0/1 – LED
deactivated/activated
bit[9]=0/1 – buzzer
deactivated/activated
bit[10]=0/1 - LED is on/off in
normal condition
bit[11]=0/1 - 1 Hz (50% on,
50% off) LED signal off/on if
relay1 turned on
bit[12]=0/1 - 2 Hz (50% on,
50% off) LED signal off/on if
relay2 turned on
0...4095, ADC units
0...65535, gas units
-32000...+32000, gas units
-32000...+32000 , gas units
-32000...+32000, gas units
-32000...+32000, gas units
19
Rev 10.03.2021
User
defined
User
defined
User
defined
User
defined