Exmark LAZER Z LZUV52 Setup Instructions page 12

hold the weight securely before lifting. Use
caution when positioning your hands so that
you do not set the weight down on your hands
or fingers.
FIGURE 19
For units SN 440,000–599,999:
7. Locate the position of the mounting holes by
aligning the template (P/N 103-5865) on the front
face of the floor pan as shown in Figure 20.
Clamp the template in place. Using a center
punch, mark the positions of the holes on the floor
pan. Flip the template over and repeat on the
other end of the floor pan face.
Align template along
these 3 edges.
FIGURE 20
8. Drill 3/8" holes at the points marked.
9. Follow steps 5 through 6 for weight installation
(See Figure19).
For Lazer XS Liquid Cooled units SN 600,000
and Higher:
10. Locate the position of the mounting holes by
aligning the template (P/N 103-5865) on the front
face of the floor pan as shown in Figure 20.
Clamp the template in place. Using a center
punch, mark the positions of the holes on the floor
pan. Flip the template over and repeat on the
other end of the floor pan face.
11. Drill 3/8" holes at the points marked.
12. Install the four weight plates behind the front
panel using the 5/16-18 x 1.50 screws,
5/16 washers and 5/16-18 whizlock nuts
(Items 34, 35, and 36). The weight plates will only
fit with the ears located near the bend in the floor
pan (See Figure 18). The decal on the outside of
the floor pan will still be visible with the weight
plates mounted.
Install the Removable Weights
Note: The removable weights are heavy. Use
care when lifting them. Make sure that you can
hold them securely before lifting them. Use
caution when positioning your hands so that you
do not set them down on your hands or fingers.
1. Assemble the weight brackets (Item 31) to the
removable weights (Item 11) using the 3/8-16
square head bolts (Item 32) and 3/8 whizlock
nuts (Item 24).
Unit
Lazer Z 52" Units, All
Lazer Z AS 60" Units, All
Lazer Z 60" Units,
SN 600,000 and Lower
Lazer Z 60" Units,
SN 600,000 and Higher
Except AS
Lazer Z 66" Units,
Lazer Z 72" Units
Lazer Z XP 60" Units
Lazer Z XP 72" Units
Lazer Z XS 60" Units
Lazer Z XS 66" Units,
Lazer Z XS 72" Units
1
1.5" bracket is included in Ultra Vac completion
kit 109-1179 or 109-1189.
2. Install the removable weight assemblies over
the caster arms. On all 52" units and some
60" units one weight has a wide mounting
bracket and one has a narrow bracket. They
will only fit the machine one way. Weights for
all other units are interchangeable left and
right.
3. Install a clevis pin (Item 19) and hairpin (Item
20) on each caster weight to retain them.
4. Tighten knob on weight assembly until the
weight is clamped securely to the caster arm.
RELEASED Version
1.5" 2.0"
Bracket Bracket
1 1
1
1 1
1
1
1
2
2
2
2
2
2
2
2
Page 12 of 13
109-4232 Rev. A
©Toro 2006-2007