Battery - Drive Medical DeVilbiss ST4D 2G Instructions For Us

EN
Warning light
Press the warning light button once to switch on the
warning light system. Press the button again to switch
off the function. When the button is pressed, the warning
light function causes all indicators to blink and the horn
sounds.
Seat
The seat can be rotat-
ed 360° and snaps into
place in 45° increments.
To rotate the seat, pull
the lever (A) under the
left side of the seat up-
wards and then rotate
the seat. Release the le-
ver and continue rotat-
ing the seat until it snaps
into place.
You can adjust the space
for your feet on the electric scooter by pushing the seat
back and forth. To shift the seat, pull the handle for shift-
ing the seat (B) upwards.
Then place the seat in the proper position, release the
handle, and continue pushing the seat until it snaps into
place.
To change the angle of the backrest, pull the adjustment
lever (C), then adjust the backrest to the desired position
and release the lever.
Removing the seat: Pull lever A upwards and rotate the
seat approx. 10° to the left and lift it up.
Mounting the seat: Before putting the seat on again, pull
lever A upwards once again and put the seat fully on.
Then release lever A. After correct mounting, the seat
must once again snap into place in 45° increments.
Important: You must hear and feel the seat snap into
place.
Caution: Bring the seat back into the forward position
before you drive.
Adjusting the armrest
The height of the armrest which can be raised upwards
can be adjusted by rotating the adjustment wheel.
22
Drive Medical GmbH & Co. KG | As per: 04.05.2020 | Errors and alterations excepted
Adjusting the steering
column
The steering column can
be adjusted in various
positions:
• Press the lever on the
steering column down-
wards and move it in
the desired position.
• Release the lever
to lock the steering
column.
Neutral lever
The neutral lever enables a release of the automatic
brake so that the electric scooter can be pushed and/or
maneuvered by hand.
To allow the scooter to be moved, the scooter should be
switched off .
In neutral mode the brakes do not grip, therefore it should
not be used if:
1. Someone is sitting in the electric scooter
2. The electric scooter is left unattended
3. The electric scooter is on a slope
Driving mode/neutral
mode
Driving mode:
Move the lever to D: The
electric scooter is driven
by a motor.
Neutral mode:
Move the lever to N: The
electric scooter is in neu-
tral mode and can now
be pushed/moved by
hand.

Battery

Battery display
The battery charge status can be read on the control
panel. When the battery is fully charged, all segments of
the display are lit. The number of elements lit decreas-
es with the decreasing capacity of the battery. When the
battery display is lit to (F), this shows that the batteries
are fully charged.
When the battery display is lit to (E), this shows a low bat-
tery charge status and the batteries must be promptly
charged. This is signaled by a warning sound and the on/
off light blinks.
Instructions for use ST4D 2G / ST4D 2G PLUS