Toyota HULUX 2020 Body Section Manual page 55

⑤ Oil pressure adjustment
If the oil pressure measurement fails to satisfy the standard
value, adjust the oil pressure as follows.
(a) Adjust the length of shackle No.2 (Dimension A).
When the oil pressure is low,
increase the Dimension A.
(Turn the shackle counterclockwise.)
When the oil pressure is high,
decrease the Dimension A.
(Turn the shackle clockwise.)
Standard Dimension A
2WD
Adjustment range
Lock nut fastening torque T = 12.5 N・m.
Oil pressure change adjusted per "A" Length
Vehicle type
2WD
(b) Adjustment with LSPV body
When adjustment is impossible with the length of shackle
No.2, move the LSPV body vertically to attain the standard
oil pressure.
When oil pressure is low, lower the LSPV body.
When oil pressure is high, raise the LSPV body.
Set nut fastening torque T = 12.5 N・m.
After adjusting with LSPV body, readjust the length (Dimension A) of the shackle No.2.
【3】-6. Brake
Change of fluid Pressure per "A" Length
0.14 MPa/mm
120 mm
103 mm ~127 mm
- 49 -